George;
I just read this and wanted to thank you for the suggestions. I'll let
you know how I make out.
Warren
George wrote:
I should have in included this in my last email. The best way to run
pwxc is from you modules.conf file. I run Red Hat,
I assume your system has a /etc/modules.conf file also.
# Quickcam 4000 Drivers
post-install pwc /sbin/insmod --force /lib/modules/<kernel
version>/kernel/drivers/usb/pwcx-2.4.20.o >/dev/null 2>&1
|| :
options pwc power_save=0 compression=3 size=cif leds=500,500 fps=10
The above will probably word wrap if your mailer isn't at full screen.
Also put your actual kernel version where pwcx is
loaded where it says <kernel version>.
This will load the pwcx module automatically after the pwc module is
loaded and pass some parameters to pwc.
On Fri, 2004-01-09 at 20:48, George wrote:
You won't get 30fps on linux. The camera actually runs at 10fps. In
windows, the "extra" fps is done in software. But 10fps is more then
enough for video conferencing. Most likely unless your on a lan you
won't come near 10fps.
It should solve your palette problem (I've never run my 4000 without
pwcx) and it will allow you to run the camera in cif mode (large video)
in GM.
|
