Re: [Ekiga-list] Problem Placing Call on PPC

[Victor Bandur <bandurvp acanac net>]

The call goes through to 500 ekiga net and the sound works fine, but the video that comes back is divided into vertical stripes, each of which is reversed left-to-right, as if the image is being seen through a Fresnell lens.  Unfortunately when I try to take a screen shot with gnome-screenshot or gimp the video area is black.

Victor



On 12/12/10 12:29, Dave Koelmeyer wrote:
> On 12/12/10 11:07 PM, Victor Bandur wrote:
>> Hi all,
>>
>> I sent this message about a week ago but received an automated email that it was too long, so I've removed the attachment to a web server.  Please see below.  Thanks!
>>
>>> I'm trying to run Ekiga 3.2.7 on Gentoo for PowerPC.  The folks over at Gentoo have asked me to report this problem to you.
>>>
>>> Ekiga starts up fine, and I can see my own video.  But when I place a call to
>>> 500 ekiga net<mailto:500 ekiga net>, 501 ekiga net<mailto:501 ekiga net>  or 520 ekiga net<mailto:520 ekiga net>, after about 30 seconds I get the
>>> response, ``Could not connect to remote host''.
>>>
>>> The software versions are,
>>>
>>> Ekiga:  3.2.7
>>> Opal:  3.6.8
>>> PTLib:  2.6.7
>>>
>>> The output of ``ekiga -d 4'' can be found here:  http://baldur.no-ip.org/ekiga-output.txt.gz.  What I did was start Ekiga, try to place the call to 500 ekiga net, then quit.
>
> I see: "PDU is likely too large (1504 bytes) for UDP datagram"
>
> Is this the error to be expected when you have more codecs enabled than is necessary? What happens if you just enable the base audio codecs (e.g Speex)?
>
>