Re: [Ekiga-list] Problem Placing Call on PPC

[Dave Koelmeyer <davekoelmeyer me com>]

On 12/12/10 11:07 PM, Victor Bandur wrote:
> Hi all,
>
> I sent this message about a week ago but received an automated email that it was too long, so I've removed the attachment to a web server.  Please see below.  Thanks!
>
> > I'm trying to run Ekiga 3.2.7 on Gentoo for PowerPC.  The folks over at Gentoo have asked me to report this problem to you.
> >
> > Ekiga starts up fine, and I can see my own video.  But when I place a call to
> > 500 ekiga net<mailto:500 ekiga net>, 501 ekiga net<mailto:501 ekiga net>  or 520 ekiga net<mailto:520 ekiga net>, after about 30 seconds I get the
> > response, ``Could not connect to remote host''.
> >
> > The software versions are,
> >
> > Ekiga:  3.2.7
> > Opal:  3.6.8
> > PTLib:  2.6.7
> >
> > The output of ``ekiga -d 4'' can be found here:  http://baldur.no-ip.org/ekiga-output.txt.gz.  What I did was start Ekiga, try to place the call to 500 ekiga net, then quit.

I see: "PDU is likely too large (1504 bytes) for UDP datagram"

Is this the error to be expected when you have more codecs enabled than 
is necessary? What happens if you just enable the base audio codecs (e.g 
Speex)?


--
Dave Koelmeyer
http://davekoelmeyer.wordpress.com/

Love Coffee?
http://www.greenbeanhouse.co.nz/