Re: [Ekiga-list] Netgear wireless to Ekiga 2.1.0 registration failed

[Damien Sandras <dsandras seconix com>]

Le mercredi 15 octobre 2008 à 14:54 -0400, Derek Wueppelmann a écrit :
> On Wed, 2008-10-15 at 20:42 +0200, helen wrote:
> > I'm experiencing the following: when I use wired ethernet (directly to
> > our wireless provider - Tecnoadsl) ekiga registers instantly, but when
> > I use wired or wireless  connection via Netgear wnr854t  it always
> > says registration  failed. I have to connect the wireless provider
> > (Netgear) receiver into the back of the Netgear wireless router then
> > connect directly to my computer.  
> > 
> >  I run the wizard for both types of network connection and it always
> > registration failed when I add the Netgear into my system .
> > 
> >  The wireless connection works perfectly for any other application I
> > use.
> 
> Have you checked the network device being used in both cases? I know
> that when I switch networks I have to switch from using eth0 to eth2 as
> my wired connection is eth0 but my wireless connection is eth2. Also I
> have found that once making this change I then need to restart Ekiga to
> get it to start using the new device correctly.
> 

3.00 fixes that issue.
-- 
 _     Damien Sandras
(o-      
//\    Ekiga Softphone : http://www.ekiga.org/
v_/_   Be IP           : http://www.beip.be/
       FOSDEM          : http://www.fosdem.org/
       SIP Phone       : sip:dsandras ekiga net