Re: [orca-list] [BRLTTY] CPU load 100% with version 3.8dev and Orca?

[Willie Walker <William Walker Sun COM>]

Hi Hermann:

This is being tracked via
http://bugzilla.gnome.org/show_bug.cgi?id=432685.

I'm on vacation this week, but will try to take a look at this when I
get back.

Will

On Wed, 2007-04-25 at 13:21 +0200, Hermann wrote:
> Hello all,
> I observed that the CPU load is 100% as soon as I start brltty together 
> with Orca. Entering:
> top
> shows that "us" and "sy" in the CPU line add up to 100%.
> A member of the Orca list suggested that switching back to 3.7.2 and 
> deinstalling python-pyrex solves the problem.
> Is this issue known? Does the use of 3.7.2 without pyrex really matter?
> One of the annoying effects of that phenomenon is a swap partition that 
> contains 800 MB data after a short time. This makes the system slow down 
> and finally unusable till I reboot my machine.
> Any ideas?
> Regards
> Hermann
> _______________________________________________
> This message was sent via the BRLTTY mailing list.
> To post a message, send an e-mail to: BRLTTY mielke cc
> For general information, go to: http://mielke.cc/mailman/listinfo/brltty