Unable to connect to wireless

[Geoffrey Leach <geoff hughes net>]

NetworkManager fails to connect to my Netgear router. Hardware function  
has been confirmed (Windoze (sigh!)) I expect that's its a config  
problem - where should I look? Here's the relevant section of the log.

NetworkManager: <information>   Activation (eth0) started...
NetworkManager: <information>   Activation (eth0) Stage 1 of 5 (Device  
Prepare) scheduled...
NetworkManager: <information>   Activation (eth0) Stage 1 of 5 (Device  
Prepare) started...
NetworkManager: <information>   Activation (eth0) Stage 2 of 5 (Device  
Configure) scheduled...
NetworkManager: <information>   Activation (eth0) Stage 1 of 5 (Device  
Prepare) complete.
NetworkManager: <information>   Activation (eth0) Stage 2 of 5 (Device  
Configure) starting...
NetworkManager: <information>   Activation (eth0/wireless): access  
point 'Netgear' is unencrypted, no key needed.
NetworkManager: <information>   SUP: sending command 'INTERFACE_ADD  
eth0                wext    /var/run/wpa_supplicant '
NetworkManager: <information>   SUP: response was 'OK'
NetworkManager: <information>   SUP: sending command 'AP_SCAN 1'
NetworkManager: <information>   SUP: response was 'OK'
NetworkManager: <information>   SUP: sending command 'ADD_NETWORK'
NetworkManager: <information>   SUP: response was '0'
NetworkManager: <information>   SUP: sending command 'SET_NETWORK 0  
ssid 4e657467656172'
NetworkManager: <information>   SUP: response was 'OK'
NetworkManager: <information>   SUP: sending command 'SET_NETWORK 0  
key_mgmt NONE'
NetworkManager: <information>   SUP: response was 'OK'
NetworkManager: <information>   SUP: sending command 'ENABLE_NETWORK 0'
NetworkManager: <information>   SUP: response was 'OK'
NetworkManager: <information>   Activation (eth0) Stage 2 of 5 (Device  
Configure) complete.
logrotate: ALERT exited abnormally with [1]
NetworkManager: <information>   Activation (eth0/wireless): association  
took too long (>40s), failing activation.
NetworkManager: <information>   Activation (eth0) failure scheduled...
NetworkManager: <information>   Activation (eth0) failed for access  
point (Netgear)
NetworkManager: <information>   Activation (eth0) failed.
NetworkManager: <information>   Deactivating device eth0.
 (Windoze (sigh!)) I expect that's its a config problem - where should  
I look? Here's the relevant section of the log.