Re: More problems

[Dan Hensley <dan hensley att net>]

Carlos Morgado wrote:

> > * Once the pilot-link is configured, the information does not seem to be
> > saved.  If I try to configure a conduit, I get an error message about no
> > pilots configured.  I then have to delete everything and start over
> > again, this time exiting gnomecc before doing anything else.  Then when
> > I go back in to gnomecc I can configure conduits.
> >
>
> try clicking through the druid, closing the pilot-link capplet, killing
> gpilotd and then configure the conduits.
> i think you will notice that right after finishing the druid you cannot edit
> the pilot succefully too. could you confirm ?
>
> cheers
>

This is what I found:
    If I go through the druid and hit finish, the pilot-link capplet "Try",
"Revert", and "OK" buttons are grayed out.  There is also nothing listed in the
Pilots section.  If I close the capplet by switching to another one and
switching back, there is also nothing saved.  I have to completely exit gnomecc
for the changes to be saved.  Another thing I noticed is that gpilotd
automatically gets killed when I finish the druid.
    The other thing I noticed is that if I get the "failed to connect" message,
I have to start and stop gpilotd to clear it up in addition to removing the
gnome-pilot.d directory before it will successfully configure.

Is that what you wanted to confirm?