Re: Getting the middle of an object to snap to grid - how?

[Michael Ross <michael e ross gmail com>]

With the grid the way I have it I can't even get to connect the line to
the resistor because the centre line of the resistor is between grid lines.

I have to turn 'Snap to Grid' off to connect the line to the resistor,
then turn it back on and it acts as you say.

I can always get a line to snap to the leg of a resistor regardless of the size of the grid and how it lines up with the leg - even when the leg is between grid lines.

Once I have attached the line to the resistor I can have the grid snap enabled and move the resistor anywhere and the line tracks, or with the grid snap off the line tracks and the resistor can be placed anywhere.

 

-- 
                    Michael E. Ross
      NC Solar Center Test Laboratory
=================================
               (919) 576-0824 best

               (919) 631-1451 cell
              (919) 513-0418 desk
           michael_ross ncsu edu
         michael e ross gmail com
   =============================


NC Solar Center : www.ncsc.ncsu.edu
Professional Directory : www.greenprofessionals.org

"The information in this email is provided by the NC Solar Center at NCSU as a public service. The Solar Center strives to provide accurate information, but does not warrant or represent the accuracy, usefulness or reliability of this information. For specific advice, we always recommend that you consult with a professional in the appropriate profession for your needs." Email correspondence to and from this address may be subject to the North Carolina Public Record Law NCGS, Ch 132 and may be disclosed to third parties