Re: VPN "Only for this address range" equivalent

[Matthew Saltzman <mjs clemson edu>]

On Fri, 2008-10-31 at 12:34 -0400, Dan Williams wrote:
> On Thu, 2008-10-30 at 13:09 -0400, Matthew Saltzman wrote:
> > On Thu, 2008-10-30 at 00:12 -0400, Dan Williams wrote:
> > > On Wed, 2008-10-29 at 15:10 -0700, Jonathan wrote:
> > > > In the old NetworkManager I could set a range of addresses to use the
> > > > VPN connection for and have the rest not use it.  I don't see this
> > > > equivalent in the 0.7.0.
> > > > 
> > > > Is there somewhere I can configure this?  I basically only want it to
> > > > use the VPN for all addresses on a certain domain.
> > > 
> > > You can add custom routes in the IPv4 tab of the connection editor for
> > > the VPN connection.  You can also check "ignore automatically provided
> > > routes" if you don't care what the server sends you.
> > 
> > Is there some way to see what the server has sent me when a connection
> > is active?
> 
> It's in the logs when you connect the VPN.  If it doesn't show up here,
> either the VPN plugin doesn't interpret that feature, or the server
> isn't sending it.

Ah, that's helpful.  But I actually had nm-applet in mind when I asked.

Thanks.

> 
> 
-- 
                Matthew Saltzman

Clemson University Math Sciences
mjs AT clemson DOT edu
http://www.math.clemson.edu/~mjs