Re: Card not showing up

[Bill Moseley <moseley hank org>]

On Tue, Aug 14, 2007 at 10:42:34AM -0400, Dan Williams wrote:
> > Network Manager is a bit verbose, so I'm not sure how much to post.
> 
> You actually snipped out the bits that matter :)
> 
> I'd like to see what happens when NM starts up or when the card is
> inserted, which will print out something like this:

I'll try again when back at the machine later today.

I think what I posted was from when the card was inserted.  You can
see the kernel messages about the card insert.  I trimmed later items
(which IIRC was due to my active wireless network timing out).


> 
> Aug 12 15:05:07 localhost NetworkManager: <info>  eth0: Device is fully-supported using driver 'e1000'. 
> Aug 12 15:05:07 localhost NetworkManager: <info>  Now managing wired Ethernet (802.3) device 'eth0'. 
> 
> Aug 12 15:05:07 localhost NetworkManager: <info>  eth1: Device is fully-supported using driver 'ipw2200'. 
> Aug 12 15:05:07 localhost NetworkManager: <info>  Now managing wireless (802.11) device 'eth1'. 

It never says that - which, I suppose, is why it's not showing up.
Maybe because the card doesn't support WPA Supplicant?  Still would
like to be able to use the card for WEP networks.

moseley tiger:~$ fgrep eth1 /var/log/syslog.0

fgrep eth1 /var/log/syslog.0
Aug 13 21:50:57 tiger kernel: [  326.944000] airo(eth1): cmd:111 status:7f11 rsp0:2 rsp1:0 rsp2:0
Aug 13 21:50:57 tiger kernel: [  326.944000] airo(eth1): Doing fast bap_reads
Aug 13 21:50:57 tiger kernel: [  327.000000] airo(eth1): WPA unsupported (only firmware versions 5.30.17 and greater support WPA.  Detected 4.25.30)
Aug 13 21:50:57 tiger kernel: [  327.000000] airo(eth1): MAC enabled 0:9:7c:ae:5d:b0
Aug 13 21:50:57 tiger kernel: [  327.000000] eth1: index 0x05: , Vpp 5.0, irq 3, io 0xa100-0xa13f
Aug 13 21:50:59 tiger avahi-daemon[5231]: Registering new address record for fe80::209:7cff:feae:5db0 on eth1.*.
Aug 13 21:51:08 tiger kernel: [  337.728000] eth1: no IPv6 routers present
Aug 13 22:00:13 tiger kernel: [  876.348000] airo(eth1): cmd:2 status:ffff rsp0:ffff rsp1:ffff rsp2:ffff
Aug 13 22:00:13 tiger avahi-daemon[5231]: Withdrawing address record for fe80::209:7cff:feae:5db0 on eth1.
Aug 13 22:00:13 tiger kernel: [  876.364000] airo(eth1): cmd:21 status:ffff rsp0:ffff rsp1:ffff rsp2:ffff
Aug 13 22:00:13 tiger kernel: [  876.380000] airo(eth1): cmd:21 status:ffff rsp0:ffff rsp1:ffff rsp2:ffff
Aug 13 22:00:13 tiger NetworkManager: <information>^Iwpa_supplicant(7994): RTM_DELLINK, IFLA_IFNAME: Interface 'eth1' removed 
Aug 13 22:00:13 tiger kernel: [  876.412000] airo(eth1): cmd:21 status:ffff rsp0:ffff rsp1:ffff rsp2:ffff


> Try just running /usr/sbin/NetworkManager --no-daemon after stopping the
> one that's currently running.

I can try that later today when I'm back on the laptop.

Thanks:

-- 
Bill Moseley
moseley hank org