Re: Card cannot scan

On Fri 27 May 2005 23:08, Derek Atkins wrote:
> Are you sure that eth0 is the wireless card?  Usually eth0 is the wired
> ethernet.

I am sure.
I don't have any ethernet connection on my laptop
(Sony Picturebook C1VFK).

[tim martha ~]$ iwconfig eth0
eth0      IEEE 802.11-DS  ESSID:""  Nickname:"martha"
          Mode:Managed  Frequency:2.457 GHz  Access Point: 02:02:2D:4A:52:80
          Bit Rate:11 Mb/s   Tx-Power=15 dBm   Sensitivity:1/3
          Retry limit:4   RTS thr:off   Fragment thr:off
          Power Management:off
          Link Quality=66/92  Signal level=-83 dBm  Noise level=-121 dBm
          Rx invalid nwid:0  Rx invalid crypt:0  Rx invalid frag:44
          Tx excessive retries:89  Invalid misc:0   Missed beacon:0

Timothy Murphy  
e-mail (<80k only): tim /at/
tel: +353-86-2336090, +353-1-2842366
s-mail: School of Mathematics, Trinity College, Dublin 2, Ireland

[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Thread Index] [Date Index] [Author Index]