Re: no wireless connection at boot to Cisco AP

[David Zeuthen <davidz redhat com>]

On Wed, 2005-01-26 at 17:24 -0500, Bill Moss wrote:
> CVS-1-26
> 
> Boot with wire unplugged. NM has not obtained a wireless connection to a 
> Cisco AP after several minutes (works fine with SMC AP).
> Plug in wire. NM gets a wired connection. hal-device-manager outputs:
> PropertyModified, device=/org/freedesktop/Hal/devices/pci_8086_101e
>   key=net.80203.rate, rem=0, add=1
>   value=100000000
>   key=net.80203.link, rem=0, add=1
>   value=1

I'm surprised to see this; are you running a 2.6.10 kernel (as required
by hal-0.4.7 on FC3 and in FC Rawhide) and what is the output of 

 /sys/class/net/eth0/carrier

where you should replace eth0 with the interface name of your wired
interface.

David