Re: ATK problem

[Philippe Bertin <philippe bertin telenet be>]

rwineland,

PKG_CONFIG_PATH should at least have a value for pkg-config to be able 
to find ("also") your new glib installation... Beware modifying 
LD_LIBRARY_PATH "just like that". You might want to change it if you 
want to be sure you use your freshly-installed glib (provided you 
installed the latter in some non-standard location, i.e. using some 
other-than-standard --prefix while running ./configure

Kind regards,

PhB

rwineland wrote:

> Hello all I am a new at this I start installing GTK. I installed
> glib-2.12.4, pango-1.14.0 with no problems but when i went to install
> ATK-1.9.0 I get the following error:
>
> checking for GLIB - version >= 2.0.0... 
> *** 'pkg-config --modversion glib-2.0' returned 2.12.0, but GLIB
> (2.12.4)
> *** was found! If pkg-config was correct, then it is best
> *** to remove the old version of GLib. You may also be able to fix the
> error
> *** by modifying your LD_LIBRARY_PATH enviroment variable, or by editing
> *** /etc/ld.so.conf. Make sure you have run ldconfig if that is
> *** required on your system.
> *** If pkg-config was wrong, set the environment variable
> PKG_CONFIG_PATH
> *** to point to the correct configuration files
> no
> configure: error:
> *** GLIB 2.0.0 or better is required. The latest version of
> *** GLIB is always available from ftp://ftp.gtk.org/.
>