Re: gnomecc and gpilotd

[Jason Wier <jwier mapletronics com>]

On Mon, 3 Jan 2000, Vadim Strizhevsky wrote:

> 
> I'll try to hit two birds with one stone...
> 
> Fabien Penso writes:
>  > Jason Wier <jwier@mapletronics.com> wrote:
>  > > 
>  > > I cannot get gnome-pilot to work.  I goto configure it with the gnomecc
>  > > and it says that I have to have gpilotd running.  I go to start gpilotd
>  > > and it says that I have to configure it with gnomecc first.
> 
> Did you go to "PilotLink" section in gnomecc or to individual
> conduits? You need to configure gpilotd via "PilotLink" item in
> gnomecc first. That message you see, as far as I know only happens
> when you go to control individual conduits before you visit
> PilotLink. there's a section in README that describes what to do in
> PilotLink tab, depending on wether you have a brand new Pilot -> use
> "send to pilot", or old pilot that was previously used wiht Windows
> -> use "get from pilot" buttons. And don't forget to "OK" the changes.
> 
> Hope this helps.
> 


I go to "Pilot Link" and I get this mesage to my console

Message: Unable to load host id information, assuming unset
Message: No pilot userid/username information located
Message: Unable to load pilot id/username, assuming unset
Message: No pilot craddle information located
Message: Unable to load pilot craddle info, assuming unset

** ERROR **: Cannot connect to the GnomePilot Daemon
aborting...


Jason