Re: The new Gnome 3 desktop won't load and run.
- From: Chris Resnik <cresnik ethz ch>
- To: <gnome-list gnome org>
- Subject: Re: The new Gnome 3 desktop won't load and run.
- Date: Fri, 11 May 2012 13:34:07 +0200
the easiest way to figure out whether your graphic card supports some 3d
hardware acceleration is to install "torcs" (racing simulator) and run
it :-)
I test my graphic card almost every day, just to make the 3d hw
acceleration does not disappear ;-)
On 11.05.2012 12:51, Jayson Rowe wrote:
On Fri, May 11, 2012 at 03:49:11AM -0500, Mr. Christian W. Strubel wrote:
Dear Jayson,
Here is what I have so far I hope it helps.
I tried the 2 commands suggested on ubuntu.com.
Command: lspci | grep VGA
Output:
00:02.0 VGA compatible controller: Intel Corporation
82845G/GL[Brookdale-G]/GE Chipset Integrated Graphics Device (rev 03)
Command: sudo lshw -C video
Output:
*-display
description: VGA compatible controller
product: 82845G/GL[Brookdale-G]/GE Chipset Integrated Graphics
Device
vendor: Intel Corporation
physical id: 2
bus info: pci@0000:00:02.0
version: 03
width: 32 bits
clock: 33MHz
capabilities: pm vga_controller bus_master cap_list rom
configuration: driver=i915 latency=0
resources: irq:16 memory:e8000000-efffffff
memory:e7800000-e787ffff
Would information about the video card be shown on the BIOS screen?
Where else should I look?
Sincerely,
--
Mr. Christian Strubel
cwstrubel gmail com
(773) 828-9785
[
Date Prev][
Date Next] [
Thread Prev][
Thread Next]
[
Thread Index]
[
Date Index]
[
Author Index]