Re: [Evolution] cannot build evolution checked out from CVS
- From: Kenny Drobnack <kenny jumpline com>
- To: evolution ximian com
- Subject: Re: [Evolution] cannot build evolution checked out from CVS
- Date: Thu, 23 Aug 2001 10:23:41 -0400
OK. Tried it again on a stock install of Slackware 8.0. I got the exact same message, so I don't think
autoconf has anything to do with it, and I doubt gcc has anything to do with it either since I didn't even
get it to go through autogen.sh. Ximian Gnome isn't required to run evolution is it? I've got the latest
versions (not from cvs) of bonobo, bonobo-conf, gtkhtml, and gal.
On 22 Aug 2001 16:58:01 -0400
Jeffrey Stedfast <fejj ximian com> wrote:
why are you using autoconf 2.50? I suspect this to be the cause of your
problems...either that or gcc 3.x suckage.
On Wed, 2001-08-22 at 17:17, Kenny Drobnack wrote:
Hi. I can't seem to get the evolution checked out from cvs to build. This is on a Slackware 8.0 box with
the additional libraries I needed to compile the evolution beta 2. I also have gcc-3.0.1, and
autoconf-2.50. Not sure if I anything else that would make things go wrong. So here's what happens. I
run ./autogen.sh --prefix=/opt/gnome, get a bunch of debugging stuff, a few warnings (available on
request) followed by the following nastiness:
Running xml-i18n-toolize... Ignore non-fatal messages.
patching file po/Makefile.in.in
Hunk #1 succeeded at 18 (offset 4 lines).
Hunk #2 FAILED at 40.
Hunk #3 FAILED at 59.
Hunk #4 FAILED at 95.
Hunk #5 FAILED at 221.
4 out of 5 hunks FAILED -- saving rejects to file po/Makefile.in.in.rej
You should update your `aclocal.m4' by running aclocal.
Running aclocal -I macros ...
autoheader: error: shell error while sourcing /tmp/ah11668/traces.sh
**Error**: autoheader failed.
evolution maillist - evolution ximian com
Programmer @ Jumpline.com
Some advice: Never pet your dog when it is on fire.
] [Thread Prev