Re: [Evolution] Pilot Conduits in Evolution 0.10

["Michael Leone" <turgon mike-leone com>]

This won't activate the pilot coinduits, will it? I was under the impression thatthere's some command line parameter that must be passed to the compiler. This simply rebuilds the normal (i.e., non-conduit-enabled) version of Evolution, doesn't it?

----- Original Message -----

From: mark

To: ctooley amoa org

Cc: evolution ximian com

Sent: Monday, April 30, 2001 3:40 PM

Subject: Re: [Evolution] Pilot Conduits in Evolution 0.10

Download the src.rpm :-)
then install (as root)using rpm -Uvh <filename>.src.rpm
this next step will depend on your distro, but if your using redhat it will install into:
/usr/src/redhat/SPECS
cd into their
and then enter:
rpm -ba <name-of-file>.spec
if u want to build for a diffent architecture than i386 just add --target=i686 or --target=i586 after it,
so say i want to rebuild evolution from a src.rpm for i686 arch heres the steps i would use:

rpm -Uvh evolution.src.rpm
cd /usr/src/redhat/SPECS
rpm -ba evolution.spec --target=i686

this will then put the finished rpm into /usr/src/redhat/RPMS/i686

then install as normal: rpm -Uvh evolution.i686.rpm

Hope that helps

Mark

On 30 Apr 2001 13:43:24 -0500, ctooley amoa org wrote:
> 
> 
> I'm of the understanding that to get the Evolution conduits to work one must
> recompile the source.  If this is the case, how would one compile an src.rpm to
> get the necessary changes and still be able to install via RPM?
> 
> Chris Tooley
> 
> 
> 
> _______________________________________________
> evolution maillist  -  evolution helixcode com
> http://lists.helixcode.com/mailman/listinfo/evolution
>