Re: [Ekiga-list] Port Forwarding

[ddb5pan2 googlemail com]

I am using a Thompson Speedtouch 716 router.

The auto eth0 connection details are:

IPv4 Setting: Auto (DHCP)
I can see a specified IP Address using protocol IPv4, as shown in the Active Network connections within Ubuntu, but I do not know if is a static IP address.

Network device:    eth0
Hardware address:    00:1d:7d:0a:01:3e
Multicast:    Enabled
MTU:    1500
Link speed:    not available
State:    Active
Transmitted packets:    33302
Transmission errors:    0
Received packets:    40246
Reception errors:    0
Collisions:    0

At the router I can see an Ip address  under RoutedEthoA
Under system config it says under the service configuration that the service name is Static IP 3 Data Ports (modified by user)

In the game or application definition section of the router I can not see any trigger protocols or trigger ports against the translated ports for the various portocols tcp/udp/tcp as previously quoted.

Robin






The above comments are in response to John Feagans's email of 03/01/10 15:53 as quoted below:

Robin, Could you clarify which router you are using and did you set up static IP in the PC and the router for the ports to forward to?

Message: 3

Subject: [Ekiga-list] Port forwarding
Content-Type: text/plain; charset="us-ascii"

An HTML attachment was scrubbed...
URL: <http://mail.gnome.org/archives/ekiga-list/attachments/20100102/77feacbf/attachment.html>

------------------------------

_______________________________________________
ekiga-list mailing list
ekiga-list gnome org
http://mail.gnome.org/mailman/listinfo/ekiga-list

End of ekiga-list Digest, Vol 42, Issue 2
*****************************************

_______________________________________________
ekiga-list mailing list
ekiga-list gnome org
http://mail.gnome.org/mailman/listinfo/ekiga-list