Re: (1) Rotating drawings in dia, (2) virtual protractor for dia

[Andrey Repin <anrdaemon yandex ru>]

Greetings, rhkramer--- via dia-list!

> I'm planning to make a new stand for my monitor (to get it as close to my desk
> as possible to relieve my neck ;-).  The existing stand leans forward by about
> 1.5 degrees.  I need to cut an angle brace to support the upright with that 
> 1.5 degree forward lean.

That's fine, but I fail to see, how it is related to Dia.
It's not a CAD program.


-- 
With best regards,
Andrey Repin
Wednesday, May 15, 2019 0:36:42

Sorry for my terrible english...