I was working with some objects; The command organ of relay (horizontal)
and Horizontally aligned diode, and I noticed that when using the Objects, Align,
Top, Middle or Bottom the two objects are not positioned where I would expect
them to be. When using the Align, Left, Center or Right they seem to work
correctly. So I tried the same test with the vertical versions of the
relay and diode and now the problem is with the Left, Center and Right alignments
and the Top, Middle and Bottom seem to work OK. I am only a user not a developer so is it possible that this
would be fixed in a future version of Dia? I like how quickly I can create a
diagram using Dia but having to mess around with the alignment to make it
presentable eats up a lot of time. This is also an issue addressed in my other
post about the objects snapping to the grid. Kind Regards, Automation Project Engineer EROWA Technology, Inc. E-Mail: jon oesterheld erowatech com "Ask
us about our MTS Promotion going on now through December 2010!" Your opinions and suggestions are very important to us as we
strive to provide the Highest Quality Customer Service! Please send any Compliments,
Comments, or Complaints directly to Erowa Technology management at chris norman erowatech com. PPlease consider the environment before printing
my email CONFIDENTIALITY NOTICE: This e-mail message,
including any attachments, is for the sole use of the intended recipient(s) and
may contain confidential and privileged information. Any unauthorized review,
use, disclosure or distribution is prohibited. If you have received this
transmission in error, please delete it from your system without copying it,
and notify the sender by reply email or contact: info erowatech com so that our address record can be corrected. Thank You. |