Re: SawfishConfig error

[Teika Kazura <teika lavabit com>]

How about debugger? Today for the first time I tried it, but it works
for the simplest case. Since it says byte-compiled files are not
supported, some care is needed.

Now the procedure:
1. copy lisp/sawfish/cfg/main.jl.in (in source) as main.jl.
2a. In main.jl, replace 'nokogiri-dir' with
    /usr/share/sawfish/1.6.2/lisp, and touch all lisp/sawfish/cfg/*
    files. (If jl source is newer than jlc, then jl is read.)
2b. Even better, replace 'nokogiri-dir' with /your-git-repo/lisp/,
    since there's no jlc files there.
3. Add (setq debug-on-error t) somewhere in main.jl
4. rep main.jl

When you enter the debugger, type 'backtrace'. (Tab completion
available.)

On Thu, 25 Feb 2010 00:04:31 +0100, Christopher Roy Bratusek wrote:
> Bad arguement: #<closure 10adc40>, (1 1 40 32), 1
> [...]
> ... since I didn't change SawfishConfig since 1.6.0, I may be some
> incompatibility between rep-gtk and gtk+ 2.19.5 (which I'm using),
> though I'm not 100% sure here.

Hmm, but it says 'closure'. rep-gtk funcs are C, so 'subr', no? I doubt
add-matcher thingy, or bogus key binding.

Regards,
Teika (Teika kazura)