Re: [GnomeMeeting-devel-list] Ekiga 1.99.1 with XLite

[thomas schorpp <t schorpp gmx de>]

Soenke Schwardt wrote:
> Damien Sandras <dsandras seconix com> wrote:
> 
>>Le lundi 13 février 2006 à 17:07 +0100, Soenke Schwardt a écrit :
>>
>>>Damien Sandras <dsandras seconix com> wrote:
>>>
>>>>I tested calls with XLite and found the following results :
>>>>- G.711: gives a robotic voice on XLite's side. I would say there is a
>>>>bug in XLite, Craig will confirm or not.
>>>
>>>Was echo cancellation activated? I just had the same problem but
>>>remote endpoint was asterisk instead of XLite. Without echo
>>>cancellation it was fine.
>>
>>So you have problems with echo cancellation and Asterisk?
> 
> 
> The person that called me yesterday (PSTN via asterisk [sipgate])
> mentioned a robotic voice. Echo cancellation was activated but I
> didn't switched it off and tested again.
> 
> A direct call to a local Cisco IP Phone 7960 resulted in the
> same audio effect. The phone plays the audio data slower,
> e.g. saying "one..two..three.." within 3 seconds results in
> "oooonnnneee... twwwooooo... ttthhhrrreeeee" on the Cisco IP Phone
> which lasts about 5 to 6 seconds. Switching echo cancellation off
> makes no difference. Sounds awful. Since the phone wasn't able to
> speak GSM, I couldn't check if other codecs are ok.
> 
> Greetings,
>  
>  Sönke
> 
> PS: I'm using Ekiga 1.99.0-20060118 debian snapshots
> 

snapshot too old.

cant confirm this. yesterday i had a 1 hour call incoming from sipgate 
asterisk. codec pcma.

everything fine.