Re: Settings seem right for m505 but no connection

[Dave Cooper <dco prismtechnologies com>]

Have you recompiled evolution against the new gnome-pilot and conduits?

If not then try this as this is necessary to get it working.

cheers

Dave

On Thu, 2002-06-20 at 00:20, Carmine F. Greco wrote:
> Patched, built, and installed pilot-link-10.99, gnome-pilot-0.1.65, and
> gnome-pilot-conduits-0.9 successfully.  I added the gnome-pilot applet
> to my panel and went through the druid (which threw error dialogs
> constantly as I went through the steps) and got all the settings in. 
> The settings are {"Handspring USB", 57600, /dev/pilot} and /dev/pilot is
> soft-linked to /dev/usb/ttyUSB1.
> 
> I push the hotsync button, and dmesg shows the following lines:
> 
> 
> hub.c: USB new device connect on bus1/2, assigned device number 9
> usbserial.c: Palm M505 converter detected
> visor.c: visor_startup
> visor.c: visor_startup - Set config to 1
> visor.c: Palm M505: Number of ports: 2
> visor.c: Palm M505: port 1, is for Generic use and is bound to ttyUSB0
> visor.c: Palm M505: port 2, is for HotSync use and is bound to ttyUSB1
> visor.c: visor_startup - length = 20, data = 01 00 00 00 63 6e 79 73 02 00 00 00 00 00 02 00 00 01 02 02 
> visor.c: visor_startup - length = 20, data = 01 00 00 00 63 6e 79 73 02 00 00 00 00 00 02 00 00 01 02 02 
> usbserial.c: Palm M505 converter now attached to ttyUSB0 (or usb/tts/0 for devfs)
> usbserial.c: Palm M505 converter now attached to ttyUSB1 (or usb/tts/1 for devfs)
> 
> 
> But gnome-pilot never sees the m505 and never syncs.  I tried linking
> /dev/pilot to /dev/ttyUSB1 but that didn't make any difference.  Any
> ideas?  TIA.
> 
> Carmine
> 
> Carmine F. Greco
> Email: cgreco1 nc rr com
> Jabber: cgreco16 jabber org 
> AOL: cgreco2
> Web: http://greco.dns2go.com