[glade--]Can't compile

[Damjan Zemljic <damjan zemljic hermes si>]

Hi,
using glade I cannot get the source that will compile on my configuration.
First, it took me quite some time to install appropriate tools and
libraries:
- compilation and installation went smoothly (after installing few packages
- automake, autoconf, glib-devel, gettext...) gtk+-1.2.10.tar.gz,
gtkmm-1.2.10.tar.gz and gtkmm-1.2.10.tar.gz
(at the beginning gtk-config script was missing on a system because gtk+ was
installed via rpm package!?)
Then I started glade, drew simple GUI and C++ code was generated.
Unfortunately, can't compile it.

[zemljic rudonja test]$ make         
./autogen.sh
**Warning**: I am going to run `configure' with no arguments.
If you wish to pass any to it, please specify them on the
`./autogen.sh' command line.

processing .
deletefiles is  macros/gnome-gettext.m4
Creating ./aclocal.m4 ...
Running gettextize...  Ignore non-fatal messages.
Wiping out intl/ subdirectory
Copying file ABOUT-NLS
Copying file intl/bindtextdom.c
   ...
aclocal: macros/linger.m4: 4: duplicated macro `AC_STRUCT_LINGER'
aclocal: macros/need-declaration.m4: 3: duplicated macro
`GCC_NEED_DECLARATION'
aclocal: macros/need-declaration.m4: 36: duplicated macro
`GCC_NEED_DECLARATIONS'

**Error**: aclocal failed. This may mean that you have not
installed all of the packages you need, or you may need to
set ACLOCAL_FLAGS to include "-I $prefix/share/aclocal"
for the prefix where you installed the packages whose
macros were not found
make: *** [all] Error 1

What could be missing? Any advise would help, since don't have idea at the
moment what to do further.

Regards,
Damjan