On 05/13/2011 07:22 PM, Eugen Dedu wrote:
First I tried the regular version, then I tried the testing version, then I tried to compile it from source: So, I tried an update from the testing repos: # yum remove ekiga # yum install ekiga --enablerepo=updates-testing Then I ran it with: $ ekiga -d 4 Much patience is required, since it takes a heckavalongtime to start up, testing the NAT firewall and connection to ekiga.net It eventually comes, up, turns grey immediately and, wait for it, drum roll... Illegal instruction (core dumped) Bleh... So, I'm back to trying to figure out how to compile and install it from source. ---------- Post added at 03:30 PM ---------- Previous post was at 01:13 PM ---------- Sooooooooooo.... $ tar -zxvf ptlib-2.6.7.tar.gz $ tar -zxvf opal-3.6.8.tar.gz $ tar -zxvf ekiga-3.2.7.tar.gz $ cd pt[tab] $ make clean $ ./configure --prefix=/usr $ make $ su # make install # exit Rinse and repeat... ...and: /usr/include/ffmpeg/libavutil/common.h:165:47: error: ‘UINT64_C’ was not declared in this scope make[2]: *** [obj/h263-1998.o] Error 1 --- Now I installed the regular version again, and ran it with -d 4: [herman@leo ~]$ ekiga -d 1 2011/05/13 20:25:17.743 0:01.869 Version 3.2.7 by on Unix Linux (2.6.35.6-45.fc14.i686-i686) with PTLib (v2.6.7) at 2011/5/13 20:25:17.742 2011/05/13 20:25:17.759 0:01.884 Ekiga git revision: unknown 2011/05/13 20:25:18.684 0:02.809 HalManager_dbusPopulating full interface list failed - Method "getDevices" with signature "" on interface "org.freedesktop.NetworkManager" doesn't exist 2011/05/13 20:25:18.685 0:02.811 Detecting V4L2 devices 2011/05/13 20:30:10.754 4:54.879 VidinputCore Tried to set malformed device 2011/05/13 20:30:10.756 4:54.881 VidinputCore Tried to set malformed device 2011/05/13 20:30:10.756 4:54.882 VidinputCore Tried to set malformed device 2011/05/13 20:30:10.759 4:54.884 AudioOutputCoreTried to set malformed device 2011/05/13 20:30:10.760 4:54.885 AudioOutputCoreTried to set malformed device 2011/05/13 20:30:10.775 4:54.900 AudioInputCore Tried to set malformed device 2011/05/13 20:30:11.531 4:55.657 Ekiga version 3.2.7 2011/05/13 20:30:11.531 4:55.657 OPAL version 3.6.8 2011/05/13 20:30:11.531 4:55.657 PTLIB version 2.6.7 2011/05/13 20:30:11.532 4:55.657 GNOME support disabled 2011/05/13 20:30:11.532 4:55.657 Accelerated rendering support enabled 2011/05/13 20:30:11.532 4:55.657 DBUS support enabled 2011/05/13 20:30:11.532 4:55.658 GConf support enabled 2011/05/13 20:30:11.532 4:55.658 ESound support disabled 2011/05/13 20:30:13.198 4:57.323 Opal Liste...0xb69beb70 Listen UDP read error. 2011/05/13 20:30:27.613 5:11.739 Housekeeper:0xb69ffb70 SIP Attempt to write PDU to closed transport udp$86.64.162.35:5060<if=udp$192.168.1.3:5060> 2011/05/13 20:30:44.165 5:28.290 Housekeeper:0xb69ffb70 SIP Attempt to write PDU to closed transport udp$86.64.162.35:5060<if=udp$192.168.1.3:5060> 2011/05/13 20:31:00.556 5:44.682 Housekeeper:0xb69ffb70 SIP Attempt to write PDU to closed transport udp$86.64.162.35:5060<if=udp$192.168.1.3:5060> 2011/05/13 20:31:00.567 5:44.692 Housekeeper:0xb69ffb70 SIP Attempt to write PDU to closed transport udp$86.64.162.35:5060<if=udp$192.168.168.1:5060> 2011/05/13 20:31:00.569 5:44.695 Housekeeper:0xb69ffb70 SIP Attempt to write PDU to closed transport udp$86.64.162.35:5060<if=udp$192.168.168.1:5060> Segmentation fault (core dumped) |