Re: [Ekiga-list] No (key?) tone when dialing

[Damien Sandras <dsandras seconix com>]

Le jeudi 20 mars 2008 à 10:25 -0700, Roderick A. Anderson a écrit :
> Good morning to all.
> 
> Sorry to have not lurked longer before asking questions.  I have done
> some searching of the archives but, probably due to a wrong concept,
> used the wrong terms.
> 
> Basically I do not hear anything when I press the dial-pad keys and it
> appears nothing is sent to the system I am connected-to/registered-with.
> 
> Fluff.  I have X-Lite (Linux) working.
> 
> Background.  CentOS 5, Ekiga 2.0.2. Alsa sound drivers,
> 
> I had this problem when I first installed Ekiga.  Then I tried X-Lite to
> make sure it was not a sound/mic hardware issue.  When I started Ekiga
> again it worked fine.  In a moment of 'superior grade stupid' I tried to
> clean-up the Ekiga installation by un-installing, killing the conf file
> and reinstalling.  (Can not remember why I thought the clean-up was
> necessary but at the time there seemed to be a reason.)
> 
> 
> Any ideas as to why there would be no tones transmitted?

Perhaps the remote end does not support RFC2833 but another way to
transmit tones. X-Lite would support the other method and not Ekiga 2.0.

Notice also that your release is a bit outdated, I would try upgrading
Ekiga.
-- 
 _     Damien Sandras
(o-      
//\    Ekiga Softphone : http://www.ekiga.org/
v_/_   NOVACOM         : http://www.novacom.be/
       FOSDEM          : http://www.fosdem.org/
       SIP Phone       : sip:dsandras ekiga net