Re: gtk 2.2.1 and pixbuf comple error

[Santanu Misra reuters com]

Hi All,

Great help. I donot know how it was happening. I did not had any "nm" and that caused the problem. I forget to check on the same as I upgraded to Mandrake 9.1 and installed gcc and binutils from the ISO cds.

So I installed binutils from TARBALL in /usr/local and very thing went  fine.

-Thanks
Santanu


                                                                                                             
                    Sven Neumann                                                                             
                    <sven gimp or       To:      Santanu Misra/EFFIX/fr EFFIX                                
                    g>                  cc:      gtk-list gnome org                                          
                                        Subject:      Re: gtk 2.2.1 and pixbuf comple error                  
                    05/05/2003                                                                               
                    03:47 PM            Header:                                Internal Use Only             
                                                                                                             
                                                                                                             
                                                                                                             




Hi,

Santanu Misra reuters com writes:

> I spend last two days with out any luck with GTK. Any help will be
> great. I tried to read the README and INSTALL and used goggle as
> much as I can but no luck.
>
> [...]
>
> generating symbol list for `libgdk_pixbuf-2.0.la'
> nm  gdk-pixbuf.lo gdk-pixbuf-animation.lo gdk-pixbuf-data.lo gdk-pixbuf-io.lo gdk-pixbuf-loader.lo gdk-pixbuf-scale.lo gdk-pixbuf-util.lo gdk-pixd
> ata.lo gdk-pixbuf-enum-types.lo  pixops/.libs/libpixops.al |  | sed 's/.* //' | sort | uniq > .libs/libgdk_pixbuf-2.0.exp
> ../libtool: eval: line 1: syntax error near unexpected token `|'

Looks as if libtool is broken. The command-line above misses a command
between the two pipe symbols. Usually, "global_symbol_pipe" as defined
in libtool is used here.

Did you compile from tarball? Did you run any commands but configure,
perhaps libtoolize or similar?


Sven






-------------------------------------------------------------- --
        Visit our Internet site at http://www.reuters.com

Get closer to the financial markets with Reuters Messaging - for more
information and to register, visit http://www.reuters.com/messaging

Any views expressed in this message are those of  the  individual
sender,  except  where  the sender specifically states them to be
the views of Reuters Ltd.