[Bug 316867] DBus' gtk-sharp dependency causes endless loop
- From: "GARNOME (bugzilla.gnome.org)" <bugzilla-daemon bugzilla gnome org>
- To: garnome-list gnome org
- Subject: [Bug 316867] DBus' gtk-sharp dependency causes endless loop
- Date: Wed, 21 Sep 2005 16:16:29 -0400 (EDT)
Do not reply to this email. You can add comments to this bug at
http://bugzilla.gnome.org/show_bug.cgi?id=316867
GARNOME | general | Ver: unspecified
------- Additional Comments From Joseph Sacco 2005-09-21 20:16 -------
You were "doing the right thing", building with "make paranoid-install"
hmmm...???
The mono dependencies for dbus came about because beagle needed dbus-sharp. As
of beagle-0.0.10 that dependency has been removed, so "we" need to rethink these
dependencies.
To get you going
-----------------
You can remove the mono dependencies from dbus an roll on. Afterwards you can
rebuild dbus with the mono dependencies.
where did the circular dependency come from?
--------------------------------------------
Not sure [yet]... I would have thought that gnome-vfs, which does not explicitly
use dbus-sharp, would have been built and installed long before any of the mono
stuff. The post-install target in the mono Makefile was put there to rebuild
dbus *after* mono had been built.
What was being built when this happened? The following grep commands may help,
grep "BUILDING" make_paranoid-install.log
grep "\[install\]" make_paranoid-install.log
-Joseph
------- You are receiving this mail because: -------
You are the QA contact for the bug.
[
Date Prev][
Date Next] [
Thread Prev][
Thread Next]
[
Thread Index]
[
Date Index]
[
Author Index]