Re: [PATCH] : new filters patch (against 1.2.3)

[Willem Riede <wriede riede org>]

I added the patch to the rpm. The patch gets applied without
errors. The spec file runs autogen.sh if configure doesn't
exist, and since configure _is_ present in the archive, it
skips that and goes straight to running ./configure.

So would forcing automake change the result? Well, I just tried
that by giviing the commands by hand, and no -- the same errors
still result :-(

Thanks. Willem Riede.
---------------------
On 2001.11.12 17:39 James McPherson - TSG Engineer wrote:
> 
> On 13 Nov 2001, 09:30:24 AM Willem Riede wrote:
> > On 2001.11.12 07:03 Emmanuel wrote:
> > > On 2001.11.11 23:41 Willem Riede wrote:
> > >> I'm trying to build balsa with your patch against 1.2.3, but I get:
> > >>
> > >> filter-file.c: In function `libbalsa_mailbox_filters_load_config':
> > >> filter-file.c:359: structure has no member named `filters'
> > >> filter-file.c:359: structure has no member named `filters'
> > >> filter-file.c:365: structure has no member named `filters'
> > >> filter-file.c:365: structure has no member named `filters'
> > >> filter-file.c:371: structure has no member named `filters'
> > >> filter-file.c:374: structure has no member named `filters'
> > >> filter-file.c: In function `libbalsa_mailbox_filters_save_config':
> > >> filter-file.c:397: structure has no member named `filters'
> > >> filter-file.c:413: structure has no member named `filters'
> > >> make[2]: *** [filter-file.o] Error 1
> > >> make[2]: Leaving directory `/usr/src/redhat/BUILD/balsa-1.2.3/libbalsa'
> > >>
> > > Humm I'm not sure my answer has been correctly sent. So here it is again
> :
> > > be sure to upload the attachment numbered 5999 within bug 63459. This
> patch
> > > applies on a clean 1.2.3 tree (previous one has to be applied after
> another
> > > filter patch, forget it).
> >
> > Yes, I used attachment 5999 to get the above result :-(
> > So again, what else could I have done wrong?
> 
> Did you run automake from the top of the balsa-1.2.3 source tree after
> applying
> the patches with gpatch -p0 and before running configure?
> 
> James C. McPherson
> --
> TSG Engineer (Kernel/Storage)           828 Pacific Highway
> APAC Customer Care Centre               Gordon NSW
> Sun Microsystems Australia              2072
> 
> Failfast panic: those controlling voices in my head have
> stopped telling me what to do.....
> 
> Read about the VOS Initiative at http://www.vosinitiative.com
> 
> _______________________________________________
> balsa-list mailing list
> balsa-list@gnome.org
> http://mail.gnome.org/mailman/listinfo/balsa-list
>